Don’t simulate your design, design your simulation! – Orlando Sardaro, Design8

orlando sardaro

Don’t simulate your design, design your simulation! – Orlando Sardaro, Design8, at 3D Printing Design & Engineering Conference on April 16, during the 3D Printing Event at Brightlands Chemelot Campus in The Netherlands.

We are used to start our design process on paper using a pencil and finish it using CAD. And that is fine. I don’t believe there is any CAD system today that is as flexible as a pencil. Continue reading “Don’t simulate your design, design your simulation! – Orlando Sardaro, Design8”

Mark Rahusen, EDS-Innovation, will speak about EDS-Innovation, 3D Casting at the 3D Printing Design & Engineering Conference

Mark Rahusen, Managing Director, EDS-Innovation, will speak about EDS-Innovation, 3D Casting at the 3D Printing Design & Engineering Conference, which will take place on 24 May 2016 at Designhuis in Eindhoven, The Netherlands.

He will detail on how to use additive manufacturing in combination of current production techniques.

About Mark Rahusen Continue reading “Mark Rahusen, EDS-Innovation, will speak about EDS-Innovation, 3D Casting at the 3D Printing Design & Engineering Conference”

“Lowering the barrier: design & engineering for everyone” – Presented by Ruud van den Muijzenberg, Shapeways

3D designing currently still is a time consuming process which often requires complex and expensive software. We realized most people don’t have the knowledge of, or don’t have the access to these tools. How can you enable those consumers to make unique products that fit better in their lives than mass manufacturing can deliver?

About Ruud van den Muijzenberg Continue reading ““Lowering the barrier: design & engineering for everyone” – Presented by Ruud van den Muijzenberg, Shapeways”